hydraulic hose specification pdf

Recommended for: Medium pressure hydraulic applications. Meets or exceeds SAE 100R17 performance specifications. Reinforcement:One wire high tensile steel braid in sizes 1/4 thru

This hose shall consist of a thermoplastic inner tube resistant to hydraulic fluids with suitable synthetic fiber reinforcement, and a hydraulic fluid and weather resistant thermoplastic cover. Specification: Metric Size SAE Dash Size ID Min ID Max OD Max Max Working Pressure MPa Min Bend Radius 3.2 -2 3.4 4.0 9.5 21 25 5 -3 4.6 5.4 11.4 21 90

Hydraulic Hose Min. Wt. Hose Hose Rated Design Bend Per Part I.D. O.D. W.P. Burst Radius Ft. Number (in.) (in.) (psi) (psi) (in.) (lbs) Hydra-Max DIN 20022-2SN NRP 2-Wire Braid Non-Skive SPECIFICATIONS Recommended for: High pressure hydraulic applications. Meets or exceeds DIN 20022-2SN performance specifications. Tube: Black, oil resistant

hydraulic lines when working next to them or shut the pressure off. 2. Wear safety glasses. 3. Do not use your hands to check for leaks. Do not touch a pressurised hydraulic hose assembly

Pressure drop in psi (pounds per square inch) per 10 feet of hose (smooth bore) without fittings. Fluid specification: Specific gravity = 0.85; Viscosity = v = 20 centistokes (C.S.), (20 C.S. = 97 S.S.U.) Pressure drop values listed are typical of many petroleum based hydraulic oils at approximately +100ºF (+38ºC).

Caterpillar was the first to design and manufacture high pressure hydraulic hose known throughout the industry as XT hose. XT hose standards far exceed industry standards still today. XT hose is impulse tested to one million cycles - twice the industry requirement - at 716 hose was tested against the DIN 20022 1SN specifications for use in

Jul 17,  · The maximum working pressure of a hose assembly comprising SAE J517 hose and hose connectors per SAE J516, SAE J518, SAE J1453, etc., shall not exceed the lower of the respective SAE maximum working pressure values. When using SAE J517 hose for marine applications, refer to SAE J1475, SAE J1942, and SAE J1942-1.

Bridgestone Hydraulic hose, couplings, and accessories are developed for hydraulic components. Follow each product’s application and specification. Avoid hose burst, leakage, and other dangers by following important steps. This catalog shows the product specifications in the format below so you can select the

Pirtek reserve the right to change technical specifications without notice High pressure hydraulic hose for jacking applications.

6.Do notuse hydraulic hose to with Gates crimpers. tr ansmit high pressure gases. 4. Wear safety glasses. Follow Good Maintenance Practices Select and Install Assemblies Fluid under pressure can With Care 1. Establish a programof cause serious injury. It can be inspection, testing and almost invisible escaping from a 1.

Caterpillar was the first to design and manufacture high pressure hydraulic hose known throughout the industry as XT hose. XT hose standards far exceed industry standards still today. XT hose is impulse tested to one million cycles - twice the industry requirement - at 133% of working pressure using both new and aged hose.