eye bolt standard pdf

Fatigue rated at 1-1/2 times the Working Load Limit at 20,000 cycles. ! All Bolts Hot Dip galvanized after threading (UNC). ! Furnished with standard Hot Dip 

Metric DIN 444 Eye Bolts are bolts with an eye (loop/ring) at one end and a threaded shank at the other. They are threaded into a pre-tapped hole or secured with a nut to a structure so that a rope or cable can be attached to the loop end. Only eye bolts with shoulders should be used to support angular loads.

Working load up to 3 times higher than the JIS eye bolt (stationary type) with an Bolt size. Working load. (t). Item code. Type. Standard below-head.

See Safe Lifting Chart on page 5. All rated capacities consider a straight vertical lift. Use CAUTION when lifting. Any angle beyond vertical (zero degree) will 

1.1.1 This standard covers only eyebolts with eyes of internal diameters capable of permitting direct engagement with eyehooks of the same lifting capacity ( working load limit ) for use with Grade T( 8 ) chain.

Crosby® S-279 Machinery Eye Bolt UNC M-279 Crosby® S-279 Machinery Eye Bolt Metric Shoulder Type Eye Bolts Shoulder Type Eye Bolts *Ultimate Load is 5 times the Working Load Limit. Maximum Proof Load is 2 times the Working Load Limit. **On Request: Special threading or as forged bolts for customer conversion. •Forged Steel - Quenched

Eye Bolt 134 Care In Use 134 Eye Nut 135 Eye Bolt - Bs4278 With Metric Sizing 136 of a standard sized nut. Where an Eye Bolt is used with a tapped hole in a plate the length of thread engagement should be at least the nominal di-ameter of the thread. Where the undercut is not sufficient to allow for an adequate engagement of the collar, a

1.1.1 This standard covers only eyebolts with eyes of internal diameters capable of permitting direct engagement with eyehooks of the same lifting capacity ( working load limit ) for use with Grade T ( 8 ) chain. 2020. 9. 28. · Our these Lifting Eye Bolts are strong and robust, and correspond to standard JIS1168.

STANDARD EXECUTIONS - DIN 580-NI: AISI 304 stainless steel. - DIN 580-A4: AISI 316 stainless steel. FEATURES AND APPLICATIONS The use of DIN 580 lifting eye bolts must take place under the following conditions: - the length of the thread of the assembly hole must be equal to the length of the thread of the pin of the eyebolt;

Eye Bolts/ Eye Nuts Eye bolts and eye nuts are used for lifting machines, appliances or any other objects which cannot be lifted by hand or by fork lift truck. Applications Range The eye bolts and eye nuts are manufactured from C15 steel, drop forged and with metric thread. Each eye bolt and eye nut is individually stamped with:

shoulder pattern eye bolts. Machinery Lifting Eye Bolts in this catalog, and other catalogs to which you may refer, could show a higher Working Load Limit (WLL), or Rated Capacity (RC). Lifting Eye Bolts have a safety factor of five times the WLL/RC with proper seating and full thread engagement. 3. The RC of an eye bolt is determined from a