smc pressure switch manual pdf

The following instructions must be followed during maintenance: Turn off the power supply Stop the air supply, exhaust the residual pressure and verify that the air is released before performing maintenance Otherwise an injury can result. -5- No.PS※※-OMV0006 Caution Do not touch the terminals and connectors while the power is on.

Law, sales of switches with the unit switching function are not allowed for use in Japan. Note 2) Fixed unit: For vacuum/compound pressure: kPa For positive pressure: MPa M5 x 0.8 ø4, ø6 one-touch fitting Rc1/8, G1/8 Rc1/8, G1/8 R1/8, NPT1/8 M5 x 0.8 1

The pressure sensor SPAU is intended for monitoring pressure of compressed air and inert gases in the piping. 2.2. General safety instructions. –. The product 

or more, the switch will be turned OFF . The default setting is to turn ON the pressure switch when the pressure reaches the centre of the atmospheric pressure and upper limit of the rated

ISE20 is a digital pressure sensor with an informative, easy to read 3 screen, 3 color display. The main screen shows the instantaneous reading in red or green, while two sub-screens can display the setting label and its numeric value in orange. ISE20

The Pressure switch is a UL approved product only if it has a mark on the body. Use the specified voltage. Otherwise failure or malfunction can result. Do not exceed the specified maximum allowable load. Otherwise it can cause damage or shorten the lifetime of the Pressure switch.

Pressure Setting Digital Pressure Switch Operation Manual ZSE80(F)/ISE80(H) Thank you for purchasing an SMC ZSE80(F)/ISE80(H) Series Digital Pressure Switch. Please read this manual

Instruction Manual Digital Pressure Switch Series ZSE40A(F) / ISE40A The intended use of this digital pressure switch is to measure, monitor and display pressure and to provide an output signal. 1 Safety Instructions These safety instructions are intended to prevent hazardous situations and/or equipment damage.

Digital Pressure Switch Operation Manual The setB data has changed unexpectedly. Press the RESET button and set all data again. Piping Piping connection Connect the piping to the pressure switch with a plug o rW fitting. The tightening torque of the piping port mu st be 8.8 Nm or less.

the switch. Reduce the supply pressure to below the max. pressure rating and then reset the switch. Apply atmospheric pressure and then reset the switch. SMC PRESSURE SWITCH RESET SET KPa SMC PRESSURE SWITCH RESET SET KPa SMC PRESSURE SWITCH RESET SET KPa (1) 1 to 5V (±5%F.S.) Load impedance: 1kΩ Max.30V, 80mA Residual voltage: 1V or less Max

Installation and Maintenance Manual GP46 Series Pressure Gauge with Switch Read this manual before using this product • The information within this document is to be used by pneumatically trained personnel only. • For future reference, please keep this manual in a safe place. • This manual should be read in conjunction with the current