ja qd bushing dimensions

FOR QD SHEAVES AND SPROCKETS USING JA, SH, SD, SDS, SK, SF, E, F, & J BUSHINGS These bushings, as well as the sprockets and sheaves for them, are each drilled with six holes (three drilled and three tapped) to allow pull-up bolts to be inserted from either side.

All dimensions in millimeters unless otherwise stated. Note - X denotes that the Taper Lock Bushing is also available with metric BUSHINGS JA TO J.

ful-grip bushings bore and keyseat dimensions JA BUSHINGS SK BUSHINGS BORE SIZES KEY SEAT BORE SIZES KEY SEAT 1/2, 9/16 1/8 X 1/16 1/2, 9/16 1/8 X 1/16

800.242.4633 99 010 USA 000 0022 0999 www @ molinebearing.com202 APERED QD BUSHING DIMENSIONS QD BUSHING A B D F L BOLT CIRCLE DIA NUMBER & SIZE OF

All dimensions in Inches. All weights are approximate. The taper-bored “QD(R)” sprocket easily fits over the tapered hub and tightening of the cap screws produces a tight press fit on the shaft.

Q.D. BUSHINGS Bushing JA to J inclusive Drilled for Standard Bushing M to W inclusive Drilled for Standard Bushing S Drilled for Standard Mounting only Standard bushings from JA through S in shaft sizes to 10″. Q.D.® Hub Assembly Types (PDF) QD Bushing Std Kwy Dimensions (PDF) Stock Q.D. Bushing Bores (PDF)

CPT steel JA bushing series, QD Bushing JA, 1/2''-1 1/4'' Bore Range, have keyseats, black oxide anticorrosion surface.

BUSHING>QD Bushing Dimensions. QD bushing with a bore is a high-quality, extremely durable, and high precision product that is manufactured out of solid steel. What really sets these JA QD-type bushings apart is the extensive quality control procedure that is done to ensure you receive a consistent and premium product. QD bushings are found in

JA Type QD style bushings are used in an extensively wide range of applications and are supplied with a broad range of bore sizes. We offer a full line of in-stock high quality precision QD bushings that are manufactured to be extremely durable and high strength.

2. QD bushing sizes JA thru W (see table on page 2) may be assembled in either conventional or reverse mounting. Size H must be assembled in conventional mounting position only. CAUTION: When mounting a product on size M thru S bushings, the hub jack holes should be positioned away from the bushing saw slot to reduce the possibility of

QD bushing sizes JA through N can be assembled in either of the two positions shown below. Sizes P through S should be assembled in position one. Position One